UMBRELLA NOT INCLUDED (We offer them in White, Sand and Blue)
Do you own a Taylor Made Anchorshade Umbrella? Our 1.10" inch ID umbrella holder is designed to work specifically with the Anchorchade III umbrella currently being offered by Taylor Made. (Mar 2021) Just pop our upright umbrella holder in the table mount, and slide your umbrella right in! (Note: You will have to remove the rubber/plastic foot from the umbrella shaft.)
Fits 2010-2013 Yamaha Boats, using the U-Shaped Taco mount.
For use with umbrellas with a shaft of 1.10" in diameter or smaller. We offer adapters for umbrellas with smaller shafts. We also offer holders for 1" and 1.5" umbrella shafts.
The JEWLS* umbrella holder is a carbon steel (fresh water) or stainless steel (salt water) fabricated piece that is powder coated in your choice of color. The holder is TIG welded by hand and is powder coated by hand (there may be a few small blemishes) but it's one of a kind!
We recommend installing your umbrella into the holder, and then drilling a 1/4" hole through the pin holes to secure your umbrella in the mount.
UMBRELLA NOT INCLUDED (We offer them in White, Sand and Blue)
These are made to order - so please allow up to two weeks for shipping.
*Please DO NOT use the umbrella holder and umbrella while underway, or with strong wind conditions. Damage to your boat may result.
*JEWLS Customs is the custom parts / fabrication division of aToolCrib and DriWash Solutions, LLC. These are made to order - so please allow up to two weeks for shipping.
Customers' photos
